不同火灾规模下隧道水幕线性喷水强度的研究

为了探究火源功率和水幕线性喷水强度对烟气特征参数和水幕阻烟隔热能力的影响，以全尺寸隧道为研究对象，采用FDS数值模拟方法，还原验证了前人使用的小尺寸模型，研究了20组工况下烟气特征参数变化的规律。研究结果表明:根据相似性原理还原后的全尺寸模型在相同工况下的模拟结果与小尺寸实验基本一致；水幕系统降低遮光率的效果随线性喷水强度增加而增强，当线性喷水强度增至一定程度时，遮光率和隔热效率无明显变化；对于中、大型规模火灾，水幕有效作用时间出现减少的情况；火源功率为5，20，30 MW的小、中、大规模的隧道火灾，综合考虑经济性和水幕效果，建议分别选择水幕的线性喷水强度为8，14，16 L/(s瘙
簚m)。     

燃煤电厂超低排放气态污染物监测技术综述

介绍了燃煤电厂超低排放气态污染物监测系统的采样系统和分析单元,分析了其各自的优缺点。对稀释抽取式、冷干抽取式和热湿抽取式3种采样方法,以及非分散红外吸收法(NDIR)、非分散紫外吸收法(NDUV)、紫外差分吸收法(DOAS)、紫外荧光法(UVF)和化学发光法(CL)5种分析方法进行对比。结果表明,冷干抽取式+紫外差分法以及稀释抽取式+紫外荧光法+化学发光法可以较好地符合燃煤电厂超低排放监测的要求。     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

具有变频器的矿井低压漏电保护研究

为了解决移动变电站低压侧为变频器供电时漏电保护装置误动的问题，提出了基于傅式算法的附加直流原理漏电保护新方法。通过理论分析和MATLAB/Simulink仿真，研究了具有变频器的矿井低压供电系统附加直流原理漏电保护，提出由傅式算法分解出采样电压直流分量以反映电缆绝缘水平的保护方法；同时分析了其他因素对直流分量的影响。研究结果表明:变频器对传统附加直流保护整定值有较大影响，易造成漏电保护装置误动且无法实现电缆的在线绝缘监测；所提出的直流分量法能准确测量电缆对地绝缘电阻，且可消除电缆分布电容、变频器载波频率、变频器输出频率等其他因素的干扰；采用该漏电保护方法，可承受变频器投入时对采样电压造成的较大冲击，不必在启动期间解除漏电保护装置，能够消除在此期间存在的人身触电安全隐患。     

Green energy generation by pressure retarded osmosis: State of the art and technical advancement—review

Pressure-retarded osmosis (PRO) is a method for converting salinity gradients to power by allowing water to flow through a semi-permeable membrane against an applied hydraulic pressure. PRO already has a long history, starting from the middle of the last century, and has rapidly improved in recent years. In this paper, we present a historical development of PRO since its inception: the development of this renewable energy process has gone through several stages, depending on technological developments, worldwide energy demands, and environmental concerns. The technological progress of the process is also studied, as well as its cost viability and environmental impact. Finally, some ideas to further develop the PRO process and mitigate its detrimental effects are discussed.     

Microbial fuel cells: Advances in electrode modifications for improvement of system performance

There is an increasing trend to conduct the researches related to Microbial Fuel Cells (MFCs) in the recent years. Limited power output has been the major obstacle for the practical application and upscaling of MFCs. Attempts have been made on electrode modifications such as anode treatments, cathode modifications with catalysts and bio cathodes developments to produce varying degrees of improved output current depending upon the types of modifications. Power density and Coulombic efficiency have been considered as the important parameters to analyze the system performances. This paper overviews on the advances made in MFCs’ researches focusing on different types of electrodes modifications along with the involved methodology. Furthermore, the system performances of different modified MFCs are compared in terms of the power density and the Coulombic efficiency.     

电网发展、清洁电源接入与地区能源效率

鉴于我国已经建成全球规模最大的超高压和特高压电网,彻底弥补了电力跨区配置的电网基础设施短板,并且为清洁电源并入电网和跨区消纳提供了完善的基础设施,不仅克服我国电力负荷中心和能源基地的区域布局不协调,而且有益于缓解日益严峻的能源利用率低下和环境污染问题。本文利用1991—2012年全国29个省市面板数据实证研究了清洁电源并网对地区全要素能源效率的影响。为保证实证结果稳健性分别在线性和非线性实证框架下采用系统广义矩估计(SYS-GMM)和面板平滑转换模型(PSTR)两种方法估计了清洁电源接入高压、超高压和特高压电网的地区全要素能源效率异质性效应。实证结果显示:(1)我国电网基础设施对地区全要素能源效率具有明显的增进效应,特别是超高压电网在促进全要素能源效率提升上表现的最为突出,在特高压骨干网架尚未形成的情况下起到了支柱性作用。(2)高压、超高压、特高压与清洁电源交互项的估计系数始终位于负数区间,反映清洁电源并网的能源效率绩效并不明显,受限于并网规模和机制缺陷,还没有发挥出全要素能源效率提升作用。(3)随着人均GDP的不断提高,各等级电网对地区能源效率的益处越来越明显,并且存在着门槛效应。(4)特高压电网对地区能源效率的积极作用主要表现在东部沿海高收入省份,这些省份作为电力消费负荷中心,大规模接入清洁电源对能源效率改善裨益明显。接下来,需要根据地区的能源禀赋结构选择清洁电源的并网模式,完善的电网基础设施、合理的电源结构还需要配置以高效的清洁电源并网机制才能不断增进地区全要素能源效率。     

燃煤电厂在线监测系统颗粒物浓度排放系数影响因素的探讨

选取上海市7家未安装气-气换热器的国控燃煤电厂作为研究对象，从煤质、除尘器、脱硫协同脱除作用以及锅炉工况负荷等方面探讨对颗粒物浓度排放系数 K值产生的影响，得出上述因素通过改变脱硫进口颗粒物浓度值影响 K值，当脱硫进口颗粒物浓度较低、波动范围较小时，其 K值也维持相对稳定的状态；当脱硫进口颗粒物浓度较高、波动范围较大时，其 K值也会发生较大的变化等结论。     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.     

A case study of an isolated wind powered electricity system meeting 100% of local demand

Using meteorological and electricity demand data for a 4-year period, electricity demand in Shetland was modeled to provide an estimate of the demand over a 30-year period from 1 January 1981. That modeled demand was then compared to estimated wind power output over the same period using the WAsP model. The wind farm output was estimated for a range of sizes of wind farm up to the consented 370 MW Viking Wind Farm in Shetland. Some wind power was available for 94% of the time and the 370 MW wind farm would meet 100% of demand for nearly 80% of the time. The statistics of single and accumulated deficits were calculated for a range of wind farms and estimates of the amount of additional generation capacity and additional power requirements were assessed. The study suggests that with storage, wind power in Shetland could meet all electricity demand in Shetland at around £130 to £150/MWh (excluding subsidy) and with a grid connection allowing the sale of excess power, those costs could be reduced.